PE micro Cyclone MAX, User Manual

Page: 30 / 88

24 Cyclone for ARM devices User Manual
Cyclone for ARM ® devices
Figure 3-20: Jumper Settings for Target Power Connection via Power In and
Power Out Jacks Of Cyclone for ARM devices
Only Jumper 5 is installed.
3.14.2 Using Cyclone for ARM devices Board Power and Power Out Jack
The target power supply is not needed. The Power Out Jack of the Cyclone
for ARM devices will act as a center positive power supply to the target
system.
Figure 3-21 shows the connections.
Figure 3-21: Via Cyclone for ARM devices Board Power and Power Out Jack of
Cyclone for ARM devices
Jumpers 2 and 3 are enabled. Jumpers 1, 4 and 5 are left open, as shown in
Figure 3-22 .