Document Number PD196-256R1
PDI-P15Q Quick Start Guide
Page 4 of 7
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 800-628-9870 FX 937-743-5664
INSTALLATION
Location
*Note: Ceiling mounted fluorescent lights and windows may produce unwanted glare and should be considered when
selecting a mounting location
TV to Arm Mounting
This television is designed to attach to a wall mounted suspension arm capable of supporting a television weighing
9.5 pounds (PDI-AA410 Series). The single coaxial cable on top of the TV is used to supply the RF signal to the
television.
DANGER: ARM RECOIL HAZARD
The safety brake pin must remain in the SAFETY BRAKE PIN HOLE whenever the television is
removed from the arm or when the arm is removed from the wall bracket to prevent the arm from
springing open.
1. Remove and save the 1/4-20
(1/4 inch x 20 threads per inch)
Socket Head Cap Screw from
the TV’s Swivel.
2. Remove the two Nose Cover
Retainer Screws and raise the
metal nose cover.
3. Slide the TV’s swivel completely
into the arm’s clevis (slot) such
that the Upper and Lower
Swivel Plates sandwich the
arm’s nose. The nose of the
support arm should rest
between each plate.
4. Align the Retainer Plate’s
mounting hole over the arm
mounting hole. Thread the 1/4-
20 Socket Head Cap Screw
through the Top Retainer Plate,
the arm’s nose and then into the
Lower Retainer Plate. Tighten.
5. The coax cable in the nose of
the arm should be joined with
the coax cable from the
television. Wrench tighten the
connection and cover by sliding
the plastic boot sections into
mating position.
IMPORTANT:
Finger only tightening of
this cable connection will result in
reliability problems weeks or months
later. Wrench tighten all “F” fitting
connections!
6. For PDI-500 series arms, remove the Safety Brake Pin from the Safety Brake Pin Hole, reattach the acorn nut
to the pin, and store the assembly inside the nose of the arm by attaching it to the coax cable using the
attached plastic clip. DO NOT store the pin inside the nose of PDI-AA410 series arms.
7. Close the metal nose cover onto the nose. Reinstall the two Nose Cover Retainer Screws.
1/4-20 Socket Head
Cap Screw
Coax Cable
Power Supply Cable
Pillow Speaker Cable
USB Port
Safety Brake Pin
Nose Cover
Retainer Screws
