INSTALLATION INSTRUCTIONS
Read these instructions thoroughly before installation or assembly. Follow the
sequence for proper assembly and operation.
NOTE: The installation, maintenance, or removal of antenna systems requires
qualified, experienced personnel.
Antenna Description:
WLP2458NGP
is designed for 3/4-inch thru-hole or bracket mount installations, detailed
below.
Contents:
A - 1 each antenna with 1 piece 3M VHB adhesive
B - 1 each steel washer
C - 2 each nuts, brass nickel plated
STEP 1:
Determine antenna/mount installation location. Ensure that the mounting surface is as flat
as possible. Space of at least 1.2-inch deep by 1.6-inch diameter is required
BELOW
the
mounting surface to allow for sufficient clearance for the mounting stud, hardware, and
cables.
STEP 2:
Cut/drill a 0.90-inch hole through mounting surface, sized and positioned as shown below.
STEP 3:
Clean mounting surface and bottom of antenna.
STEP 4:
Remove the released paper of the adhesive on antenna bottom.
STEP 5:
Position antenna onto mounting surface. Mounting stud shall be located in the hole.
STEP 6:
On bottom side of mounting surface, slide slotted nut around cables and assemble to
mounting stud.
Tighten until the adhesive of antenna is compressed.
3M VHB adhesive
A
B
C
STEP 7:
Connect with the cable assembly (TNC Male of the cable to the TNC Female of the
antenna).