PCTEL SeeGull EXflex, Reference Manual

Page: 12 / 23

SeeGull
®
EX flex
®
Reference Manual
PCTEL, Inc., RF Solutions Page 12 Revision F
3.2. Setup
The following steps explain how to connect
the unit to the host PC and power source
and to begin collecting data.
1. Connect the antennas to the SMA
connectors on the unit ( Figure 6 ).
2. Connect the GPS antenna (or input)
to the SMB connector.
3. Connect the USB data cable to both
the SeeGull EX flex scanning
receiver and to a PC USB port.
4. Connect the power cable to the
SeeGull EX flex Scanning Receiver
and to the car cigarette lighter
adapter. After the power is applied,
the LED on the receiver blinks
orange. After a short delay, the light
turns green. If the light turns dark
red, the unit has failed the power-up
test. Please contact Customer
Support.
5. Install and start the PC program. If
you are using SeeHawk refer to the
SeeHawk User Manual for specific
instructions.
6. The system is ready for use.
Figure 6 - SeeGull EXflex Scanning Receiver front
display
3. USB data connector
1. SMA Connector
to RF antenna
4. Power connector
2. SMB Connector to GPS antenna