© PCE Instruments
6
5.4.5
Format
Here you can format the microSD card in the borescope. All data on the card will be irrevocably
deleted. Confirm your setting with the OK key.
5.4.6
Reset everything
To reset the instruments to factory settings, select "Yes" in this menu item. Selecting "No" takes
you back to the menu. If the instrument can no longer be operated, you can also use the reset
key on the side of the instrument.
5.4.7
FW update
If a firmware update is available for the instrument, it can be installed via this menu item.
6
Rechargeable batteries
The batteries can be charged within the unit with the supplied mains adaptor, as well as with the
external charger when removed.
6.1
Remove batteries
To remove the batteries, proceed as follows:
1.
Loosen the screw of the bottom cover of the instrument.
2.
Pull the battery unit out of the borescope.
3.
Open the battery compartment by pulling off the cover.
4.
Replace the batteries and reassemble the unit in reverse order. Make sure that the
polarity is correct!
6.2
External charging
After removing the batteries from the instrument, place them in the charger. Make sure that the
polarity is correct! As soon as the batteries are fully charged, you can re-insert them into the
instrument.
Note:
The batteries need approx. 8 hours to fully charge.
