Manual
4
4
System description
Calibration button
Material select button
Ultrasonic sensor
mm / inch button
Minus button
Calibration standard
Plus button
Display
Sensor connection
Velocity button
Power button
5
Material selection
Push the power button on the device in order to switch it on. After doing so please push material selection
button and the button will either show “cdxx” or “xxxx”. “cd” stands for code and “xx” gives information on
the material number which ranges from 1 to 11. “xxx” is the adjusted velocity speed of the material that is
to be measured.
No.
Code
Material
1
cd01
Steel
2
cd02
Cast iron
3
cd03
Aluminum
4
cd04
Copper
5
cd05
Brass
6
cd06
Zinc
7
cd07
Quartz glass
8
cd08
PE
9
cd09
PVC
10
cd10
Grey cast iron
11
cd11
Ductile iron
12
xxxx
Velocity speed
Push the plus or minus button to choose a material code and apply the chosen code with the material
selection button. The display will now show
“0”. When you choose a code without pushing the material
selection button the device will display “0” after a few seconds, too. If you do not accept a certain code
the settings will not be saved. When pushing the plus button when “cd11” is displayed you will get the
adjustment of the velocity speed. When pushing the minus button when “cd01” is displayed you will also
be able to adjust the velocity speed.
It is essential that you choose the material before the first measurement. Otherwise the measured data
might be incorrect.
