9
adjust the height of microscope and make the distance between the tested
object with the surface of lens is around 30mm, and then turn softly the
manual zooming nut till get the clearest picture
Remarks:
the moving carrier plate is recommended to be used to keep
the tested object in right center position..Motorized watching
device should be not turning when adsjusting,
2)
Adjust the magnification
:
slightly turn zooming circle of the verifocal lens to adjust the
magnification.
3)
3D imaging
:
when the suitable magnification is adjusted ready and the clear picture
effect shows rotating clockwise or counterclockwise, move the tested
object gently, make the rotating picture is in the middle of the screen
(moving carrier plate will do more easily). If the picture effect gets worse
when rotating, gently turn the zooming circle again to make it better.
Remarks:
the smaller the magnification is, the wider the view filed of
the scope is, on the contrary, bigger view filed for bigger
magnification.
4)
Adjusting the motorized watching device:
The rotating of watching device is controlled by micro-motor.Then
rotating direction is controlled by the button on the right side of
base.Turn button to
“
CW
”
,it rotates clockwide, Turn button to
“CCW”,it rotates anticlockwise;The switch and speed control of
watching device is controlled by the button
“ ”
on the left side of
base.
5)
Adjusting the brightness:
Adjusting brightness of the LED lamp
press button
“
/OK
”
, the
correspondent mark appears on the right up corner of the screen , and
the lamp is on (direct pressing “+”or “-“ will also turn on the LED
lamp). Once the lightness becomes ideal, press button
“
/OK
”
to
10
confirm. And press button
“
/OK
”
again to turn off the LED lamp.
Adjusting brightness of the halogen lamps
brightness adjusting rings for
halogen lamps are in the left side of the base of the unit, turn the
corresponding rings to get ideal brightness.
6)
Adjust the parameters of the image & system setting:
OSD can be adjusted via function buttons. OSD includes “image” and
“settings”.” While “image” includes “brightness”, “contrast”,
“saturation” and “hue”, users can adjust these parameters at their wills.
“Settings” includes “language”, “reticle”, and “reset”.
“language”: 9 languages available.
“reticle”: 10mm for a big graduation of reticle while 5mm for a small
one. (Notes: the reticle is just for reference only.)
“reset”: recover the factory settings.
Image adjusting:
a. press “MENU” to enter into the sub-menu “image”.
b. press “MENU” again and the option “brightness” is selected and ready
for adjustment
