z
The battery switch should be at ‘ON’ condition before charging.
z
Plug the power adapter into the mains supply power socket and then plug the charger connector
into the power jack of the instrument. If the instrument is in power off condition, it will turns on
automatically after the charger plug is inserted into the power jack. The battery symbol will
alternately shows between
and
when charging. The more of the dark part indicates
the more close to full capacity.
z
When the battery is fully charged, the battery symbol on the display will glint
.
z
Please use the configured AC-DC adapter to charge the battery pack.
Warning: When the battery pack is being charged, printing or paper feeding is unavailable.
5.13 Battery Replacement
When the battery pack fails to be charged, the user should replace the batteries following the program
below:
z
Power down the instrument.
z
Take off the battery compartment cover and take out the battery pack.
z
Insert the connection plug of the new battery pack into the socket on the circuit board.
z
Reset the battery cover.
z
Turn on the instrument to check.
Warning: Please pay much attention to the polarity of the battery during battery replacement.
5.14 Connecting to a Computer
Insert one connection plug of the transmission cable into the USB socket on the right side of main
body, and insert the another plug into the USB port on the back of computer box. Refer to the manual
of the DataPro software for detailed information.
5.15 Error Code Reference
Error Code
Explanation
Error Code
Explanation
E00 Battery
exhausted E05
Can not print
E01
Value out of range
E06 Battery
Charging
E02
Measurement not finished
E07
No paper for printing
E03
Data already saved
E08 Over
Temperature
E04
No memory data
E09
6 Maintenance & Servicing
6.1 Impact Device Maintenance
z
After the impact device has been used for 1000--2000 times, please use the nylon brush provided
to clean the guide tube and impact body. When cleaning the guide tube, unscrew the support ring
first, then take out the impact body, spiral the nylon brush in counter-clock direction into the
bottom of guide tube and take it out for 5 times, and then install the impact body and support ring
again.
z
Release the impact body after use.
z
Any lubricant is absolutely prohibited inside the impact device.
