© PCE Instruments
5
3.7
View Memory
•
Use the “Mem” button to enter the memory storage for last 99 measurement values
•
“0” (in white colour) will appear to the left of the main reading (main reading still
shows the
current measured value), press “+” or “-” to browse the saved values one
by one
•
“1” indicates the latest value previous to current measured value, “2” is the second
latest, etc
Please refer to below figure:
•
Use the
“Mem” button again to exit the memory storage.
•
When the meter is switched off (automatically or manually) or initialization is carried
out, the saved values will be cleared, and the measurement counter returns to zero.
3.8
SI and CO measurement mode
By default, the meter is in single measurement mode after start-
up and “SI” appears on the screen.
Press the “+” and ”-” buttons at the same time to enter continuous measurement mode. “CO” will
appear on the screen. In this mode, the probe keeps moving on the measured surface. During
one cycle of continuous measurement, 10 measurements will be acquired and the data will be
saved automatically.
Press the
“+”and”-” buttons again to exit CO mode.
Please refer to below figure:
Important note:
•
Continuous measurement may cause damage to the probe and measured surface.
Please use with caution!
