Model Number
086E80
ICP® IMPACT HAMMER
Revision: C
ECN #: 44362
Performance
ENGLISH
SI
Sensitivity(± 20 %)
100 mV/lbf
22.5 mV/N
[2]
Measurement Range
50 lbf pk
222 N pk
Resonant Frequency
≥
100 kHz
≥
100 kHz
Non-Linearity
≤
1 %
≤
1 %
[1]
Electrical
Excitation Voltage
20 to 30 VDC
20 to 30 VDC
Constant Current Excitation
2 to 20 mA
2 to 20 mA
Output Impedance
<100 Ohm
<100 Ohm
Output Bias Voltage
8 to 14 VDC
8 to 14 VDC
Discharge Time Constant
≥
100 sec
≥
100 sec
[1]
Physical
Sensing Element
Quartz
Quartz
Sealing
Epoxy
Epoxy
Hammer Mass
0.17 oz
4.8 gm
[3]
Head Diameter
0.25 in
6.3 mm
Tip Diameter
0.10 in
2.5 mm
Hammer Length
4.2 in
107 mm
[3]
Electrical Connection Position
Side
Side
Extender Mass Weight
0.044 oz
1.25 gm
Electrical Connector
5-44 Coaxial
5-44 Coaxial
[4]
All specifications are at room temperature unless otherwise specified.
In the interest of constant product improvement, we reserve the right to change specifications without notice.
ICP
®
is a registered trademark of PCB Group, Inc.
NOTES:
[1]Typical.
[2]Steel tip with no extender mass.
[3]With plastic handle attached.
[4]With aluminum handle attached.
[5]See PCB Declaration of Conformance PS136 for details.
SUPPLIED ACCESSORIES:
Model 001A20 Case (1)
Model 018G10 Miniature coaxial cable, vinyl insulation jacket, 10-ft, 5-44 to 10-32 coaxial plug
(1)
Model 080A109 Petro Wax (1)
Model 084A13 Extender mass (1)
Model 084A14 Plastic handle assembly (2)
Model 084A17 Aluminum handle with 5-44 connector (1)
Model 084A28 Vinyl impact cap, red (3)
Model HCS-2 Calibration of Series 086 instrumented impact hammers (1)
3425 Walden Avenue, Depew, NY 14043
Phone: 716-684-0001
Fax: 716-684-0987
E-Mail: [email protected]
[5]
OPTIONAL VERSIONS
Optional versions have identical specifications and accessories as listed for the standard
model except where noted below. More than one option may be used.
Entered: JM
Engineer: NJF
Sales: RWM
Approved: NJF
Spec Number:
Date: 6/29/2015
Date: 6/29/2015
Date: 6/29/2015
Date: 6/29/2015
38869
