29
Chapter 3: BIOS Setup Utility
Press <Esc> to return to the main menu setting page.
This page sets up some parameters for devices installed on the PCI bus and those
utilizing the system plug and play capability.
PCI / PnP Setup Page
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
PCI / PnP Setup
Help Item
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Load Default Settings
Resume By PCI/PCI-E/Lan PME
These items specify whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or compo-
nent is detected.
Resume By RING
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming
call on the modem) awakens the system from a soft off state.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its operating
status.
Resume on RTC Alarm
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system’s RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Resume By PS2 KB (S3)
This item enable or disable you to allow keyboard activity to awaken the system
from power saving mode.
Resume By PS2 MS (S3)
This item enable or disable you to allow mouse activity to awaken the system from
power saving mode.
Init Display First
PCI
Allocate IRQ to PCI VGA
Yes
Select which graphics
controller to use as
the primary boot
device.
Init Dispaly First
This item allows you to choose the primary display card.
