9
1.
Unhook the CPU socket’s locking lever by pulling
it away from socket and raising it to the upright
position.
2.
Match the pin 1 corner of CPU socket to the one of
processor, and insert the processor into the socket.
Do not use force.
3.
Push the locking lever down and hook it under the
latch on the edge of socket.
4.
Apply thermal grease to the top of the CPU.
5.
Lower the CPU fan/heatsink unit onto the CPU and
CPU socket, and then use the retention module
clamps to snap the fan/heatsink into place.
6.
Plug the CPU fan power cable into the CPU
cooling fan power supply (CPUFAN1) on the
motherboard.
Installing The Memory Modules
This motherboard accommodates two 184-pin 2.5V DIMM
sockets (Dual Inline Memory Module) for unbuffered
DDR333
/266 memory modules (Double Data Rate SDRAM),
and maximum 2.0GB installed memory.
DDR SDRAM is a type of SDRAM that supports data transfers on
both edges of each clock cycle (the rising and falling edges),
effectively doubling the memory chip’s data throughput.
DDR1
DDR2
Summary of Contents for M825G Series
Page 18: ......
