3.
Remove the hub sections and replace them with the new
ones (Figure 11).
a.
Slide the new hub spindle on the shaft. Be sure the
notch fits over the raised portion of the hub flange.
b.
Slide the hub sections on to the shaft with the open
ends facing out. The hub section that fits against the
hub spindle has two curved grooves instead of peg
holes. Be sure the slot in this section is aligned with
the smaller side of the hub spindle. Also be sure the
slots in the rest of the hub sections are aligned with
this section.
c.
Slide the hub end on.
NOTE:
For a four or six inch long hub, screw on the
extension shaft before you install the hub
sections.
d.
Screw the hub knob on.
Figure 11
Hub
Spindles
Hub
Hub
Knob
Hub
End
Extension
Shaft
Monarch 415 Rewind Operator’s Handbook
10
