Taking the Boot off the Printer ––––––––––––––––––––––––––––––––
To take the boot off the printer:
1. Industrial Version Only.
Remove the cable from the side
of the printer. Save the spacers and longer screws for
when you want to use the printer with the boot.
2. With Shoulder Strap Only.
Unscrew the knob assemblies
on both sides of the printer (including the shoulder strap, if
used), and take them off.
3.
Pull on the boot and remove it from around the printer.
4.
For both sides of the printer (at the top), put the screw
assemblies together (including either shoulder strap, if
preferred), put them into the threaded inserts and screw
them in.
n
Do not over-tighten the assembly.
5. Industrial Version Only.
Reattach the cable using the
shorter screws without the spacers.
Chapter 6. Using the Boot
6-3
TC9490OH Rev. C 3/97
