7
Cut out the center wheel opening on the wheel pants on the side with the wood-mounting block.
With the aircraft resting on the landing gear, we are going to need to set the right angle for the wheel
pants. We used a standard servo and placed it at the end of the pant resting the end on the rubber
grommets of the servo. Mark the drilling location for the 4/40 bolts.
Drill the holes for the 4/40 bolts in the wheel pants at the locations you’ve marked.
Apply some white wood or epoxy glue to the inner side of the four 4/40 blind nuts and install the blind
nuts to the inside of the wheel pants.
Now you can install the wheel pants with the 4/40 bolts and washers. Don’t forget to use loc-tite here
again. Wheel pants tend to take the most vibration.
