Loading the Configuration (optional)
34
SmartNode 4170 User Manual
4
• Initial Configuration
Note
The SN4171 does not have routing and NAT functions enabled by default.
They can be enabled by purchasing the corresponding software licenses.
Figure 11. Connecting the SmartNode to the network
You can check the connection with the ping command from the SmartNode to another host on the network.
172.16.1.99(if-ip)[WAN]#ping <IP Address of the host>
Note
If the WAN address is
not
set to DHCP, to ping a device outside your local
LAN you must first configure the default gateway. (For information on con-
figuring the default gateway, refer to section “Set IP addresses” in the Trinity
Release 3.5.x– Command Line Reference Guide.)
Note
Connecting both Ethernet ports to the same switch will only work if the
switch has separate ARP tables for each connection.
Note
IP Routing is disabled on SN4171 models. See Software license options to
enable it.
Loading the Configuration (optional)
The Patton Community provides several Web Wizards to help with setting up your SmartNode configuration.
Patton also provides a collection of configuration templates on the support page at:
http://www.patton.com/support/kb.asp
—one of which may be similar enough to your application that you
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
For the ISDN connection to a carrier network, it shall be con-
nected to a network termination device and not connected
directly to an outside POTS line.
CAUTION
CAUTION
