Patton SmartNode 4110 Series, User Manual

Page: 36 / 77

Installing the gateway router 36
SmartNode 4520 & 4110 Series User Manual 3 • Hardware installation
Connecting to external power source
CAUTION
The terminal block header to which the wires are secured pro-
vides the disconnect for the SmartNode. Take proper measures
to ensure that it is not permanently fastened to the receptacle
mounted on the chassis.
The router comes with an internal or external power supply. This section describes installing the power cord
into the router. Do the following:
Note
Do not connect the power cord to the power outlet at this time.
1.
If your unit is equipped with an internal power supply, go to step 2. Otherwise, insert the barrel type con-
nector end of the AC power cord into the external power supply connector (see
figure 22 ).
2.
Insert the female end of the power cord into the internal power supply connector (see figure 22 ).
Figure 22. Power connector location on rear panel