23
FR, CH
Liste des pièces
Avant de procéder au montage du cuiseur : Lire attentivement les instructions. Vérifier la présence de toutes les pièces
en consultant la liste des pièces.
Effectuer le montage sur une surface lisse pour éviter de rayer la peinture. Conserver ces informations pour toute
référence ultérieure.
Pour faciliter le montage, dans un premier temps, ne serrer que légèrement les boulons, ils devront être serrés
complètement à la fin du montage.
AVERTISSEMENT : NE PAS serrer les vis excessivement ; serrer uniquement à une pression modérée pour éviter
d’endommager les boulons ou les éléments du cuiseur ou grill Kamado.
Instructions de montage
IMPORTANT : Retirer tout emballage avant d’utiliser le cuiseur, mais conserver les instructions de sécurité à proximité du
produit.
MONTAGE
ÉTAPE 1: Fixer les quatre roues pivotantes préfiletées (2 et 3) à chacun des quatre supports (1) en les enclenchant
dans l’orifice prévu à cet effet. En utilisant une clé à molette, serrer chaque roue pivotante avec l’écrou (B)
correspondant.
ÉTAPE 2: Pour monter le chariot, insérer les deux pièces transversales (4) dans l’un des quatre supports (1) à partir du
haut et du bas.
ÉTAPE 3: Insérer les pièces transversales (4) dans les trois autres supports (1).
ÉTAPE 4: Fixer les supports (1) aux pièces transversales (4) en utilisant les 16 vis (A). Veiller à ce que le chariot soit
sécurisé et à ce que toutes les vis soient serrées avant de placer le grill Kamado (9) dans le chariot.
ÉTAPE 5: Pour placer le cuiseur Kamado (9) sur le chariot, retirer d’abord tous les éléments qui sont à l’intérieur du grill
afin de soulever celui-ci plus facilement.
STORAGE
• When not in use, and if stored outside, cover the Kamado once completely cooled with a suitable rain cover.
• The chrome plated cooking grill is
NOT
dishwasher safe; use a mild detergent with warm water.
• When using the Kamado push down on both of the locking wheels to stop the unit moving about during use.
• It is recommended the Kamado be stored under cover in a garage or shed over winter for complete protection.
CLEANING
• The Kamado is self cleaning. Heat it up to 260ºC for 30 minutes and it will scorch off all of the food and debris.
•
DO NOT
use water or any other types of cleaning product to clean the inside of your Kamado. The walls are
porous and will absorb any fluids used, this could cause the Kamado to crack. If the soot becomes excessive
then use a wire brush or the ash tool (not supplied) to scrape off the carbon remnants before the next use.
• To clean the grills and grates use a non-abrasive cleaner once the unit has fully cooled.
• To clean the outer surface wait until the Kamado is cool and use a damp cloth with a mild detergent.
MAINTENANCE
• Tighten the bands and oil the hinge 2 times a year or more if needed.
LIGHTING, USAGE AND CARE INFORMATION
• Ensure the Kamado is positioned on a permanent, flat, level, heat resistant non-flammable surface away
from flammable items.
• Ensure the Kamado has a minimum of 2m overhead clearance and has a minimum 2m clearance from
other surrounding items.
•
To start a fire place rolled up
in the base of the Kamado. Then place 2 or 3 handfuls of lump charcoal over the top of the newspaper.
•
DO NOT
use petrol, white spirit, lighter fluid, alcohol or other similar chemicals for lighting or relighting.
•
Open the bottom vent and light the newpaper using a long nosed lighter or safety matches. Once it has
caught, leave the bottom vent and lid open for about 10 minutes to build a small bed of hot embers.
• Allow the charcoal to heat up and be kept red hot for at least 30 minutes prior to the first cooking on the
kamado.
DO NOT
cook before the fuel has a coating of ash.
• It is recommended you don’t stoke or turn the coals once they are alight. This allows the charcoals to burn
more uniformly and efficiently.
•
Once alight
ONLY
use heat resistant gloves when handling hot ceramics or cooking surfaces.
•
See below for cooking instuctions depending on temperature and duration.
LOW TEMPERATURE COOKING GUIDE
•
Light the lump charcoal according to the the instructions above.
DO NOT
move or stoke the coals once lit.
• Open the bottom vent fully and leave the lid open for about 10 minutes to build a small bed of hot embers.
• Monitor the Kamado until it has risen to the desired temperature. See page 4 for a temperature cooking guide.
•
Fully close the bottom vent to maintain the temperature.
• You are now ready to use the Kamado for cooking on.
•
IMPORTANT:
When opening the lid at high temperatures it is essential to lift the lid only slightly, allowing air
to enter slowly and safely, preventing any backdraft or flare-ups that may cause injury.
•
ALWAYS
follow the
FOOD COOKING INFORMATION
stated on page 4 of this instruction manual.
•
ALWAYS
use heat resistant gloves when handling hot ceramics or cooking surfaces.
SMOKING GUIDE
•
Follow the instructions above as if you were starting a slow cook.
• Monitor the Kamado until it has risen to the desired temperature. See page 4 for a temperature cooking guide.
•
Leave the bottom vent slightly open.
•
Close the top vent and continue to check the temperature for a few more minutes.
•
Using heat resistant gloves sprinkle the wood chips in a circle over the hot charcoal.
• You are now ready to use the Kamado to smoke on.
•
TIP:
Soak your wood chips or cooking planks in water for 15 minutes to prolong the smoking process.
•
IMPORTANT:
When opening the lid at high temperatures it is essential to lift the lid only slightly, allowing air
to enter slowly and safely, preventing any backdraft or flare-ups that may cause injury.
•
ALWAYS
follow the
FOOD COOKING INFORMATION
stated on page 4 of this instruction manual.
•
ALWAYS
use heat resistant gloves when handling hot ceramics or cooking surfaces.
5
IMPORTANT -
Remove any packaging before use, but retain the safety instructions and store them with this product.
Ensure that the lid is closed prior to assembly.
Assembly instructions
Parts list
WARNING - DO NOT
over tighten bolts; only tighten with moderate pressure to avoid damaging the bolts or
components of the Kamado Grill.
Prior to assembly, read the instructions carefully. Check all parts against the parts list.
Carry out assembly on a soft surface to avoid scratching the paint. Please retain this information for future reference.
For ease of assembly only loosely tighten bolts and then tighten fully when assembly is complete.
1
B
2
STEP 1 -
Attach the four pre-threaded castor wheels (2 & 3) to each of the four brackets (1) by pushing them
through
the hole. Using an adjustable spanner secure each castor wheel with 1x nut (B).
2 (2x)
3 (2x)
6 (1x)
5 (1x)
10 (
2
x)
11 (1x)
12 (
1
x)
13 (
�
x)
14 ( x)
15 (2x)
7 (1x)
8 (1x)
9 (1x)
1 (4x)
4 (2x)
C (2x)
D (2x)
A (16x)
B (4x)
E (2x)
F (4x)
G (2x)
H (2x)
16 (2x)
1
1
Summary of Contents for Kamado 21
Page 30: ...OPERATING AND ASSEMBLY INSTRUCTIONS Kamado 21 WITH BLUETOOTH SMART THERMOMETER AND LED LIGHT...
Page 43: ...BEDIENUNGS UND MONTAGEANLEITUNG Kamado 21 MIT BLUETOOTH THERMOMETER UND LED BELEUCHTUNG...
Page 57: ...ISTRUZIONI D USO E DI MONTAGGIO Kamado 21 CON BLUETOOTH THERMOMETRO E ILLUMINAZIONE A LED...
