Inserting and Removing SFP Modules
26
FiberPlex FP1004E User Manual
2
• Installation
.
Removing a Module
1.
Attach an anti-static wrist or ankle strap, following its instructions for use.
2.
Disconnect and remove all interface cables from SFP module.
3.
Release the latching mechanism (see
).
– Bail Clasp—Open the bail clasp on the SFP module with your finger in a downward direction.
– Actuator Button—Gently press the actuator up (or in) while pulling the body of the SFP module to
release the SFP module from the cage.
– Mylar Tab—Pull the tab gently in a straight outward motion until it disengages from the port. Make
sure the tab is not twisted when pulling as it may become disconnected from the SFP module.
Figure 14. Releasing the latching mechanism
– Slide Tab—With your thumb, push the slide tab on the bottom front of the SFP module in the direc-
tion of the equipment to disengage the module from the line card port (see
). If you pull on the
SFP module without disengaging the tab, you can damage the SFP module.
Figure 15. Releasing the slide tab
4.
Grasp the SFP module between your thumb and index finger and carefully remove it from the port (see
5.
Place the SFP module on an anti-static mat, or immediately place it in a static shielding bag or container
