Patton CopperLink CL1211E, User Manual, Page: 17 / 48

Planning the Installation 17
CopperLink CL1211E/CL1212E User Manual 2 • Installation
Planning the Installation
To install the CL1200E Ethernet Extender, do the following:
1.
Install accessories (see section “Installing accessories” )
2.
Connect a cable to the Line interface (see section “Connecting the Line Interface” )
3.
Connect an Ethernet cable to the Ethernet interface (see section “Connecting the 10/100Base-T Ethernet
Interface” on page 25)
4.
Connect the power supply cable to the Pwr port (see section “Connecting Power” on page 26)
Installing accessories
Note
If the only accessory your device has is the power cord, proceed to section
“Connecting the Line Interface” on page 23.
This section describes installing the following accessories that may have been purchased along with the
CL1200E:
• DIN Rail Installation Kit; 35MM (see section “Installing the DIN Rail Installation Kit; 35MM (INS/A-
DIN-35)” )
• 19" Rackmount Adjustable Depth 35MM DIN Rail Kit (see section “Installing the 19" Rackmount Adjust-
able Depth 35MM DIN Rail Kit (NS-1001R-19ADJDIN)” on page 20)
• Mounting Ears Installation Kit (see section “Installing the Mounting Ears Installation Kit (INS-KIT-
MNTEARS)” on page 21)
• Mounting Plate Installation Kit (see section “Installing the Mounting Plate Installation Kit (INS-KIT-
MNTPLATE)” on page 23)
Installing the DIN Rail Installation Kit; 35MM (INS/A-DIN-35)
Do the following to install the DIN Rail installation kit:
1.
Using a cross-tip screwdriver, remove the four screws from the rear panel of the CL1200E as shown in
figure 3 on page 18.
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION