ForeFront
™
Document Number: 13404U4-001 Rev. B
Part Number: 07MPMC-CPCI-IG
Revised: February 20, 2012
page 2
Remove the PMC slot 2 protective cover from the Model 6081RC front panel (see
figure 1
on page 1).
Note
: The Model 6081RC has two PMC expansion slots, numbered 1 and 2 (see
figure 1). The PMC Ethernet Access Module must only be installed in PMC
slot 2, do not install the PMC Ethernet Access Module in PMC slot 1.
Insert the front panel of the PMC card into the cutout for PMC slot 2 on the front panel
of the Model 6081RC.
Align the two connectors on the PMC card with the corresponding connectors on the
Model 6081RC (see
figure 1
on page 1).
Gently and firmly press down on the rear of the PMC card, so that the connectors
mate and snap into place.
Install the 4 fastening screws as shown in
figure 1
on page 1. Gently tighten the
screws into place.
EC Declaration of Conformity
This equipment conforms to the requirements of Council Directive 1999/5/EC on the approximation of the
laws of the member states relating to Radio and Telecommunication Terminal Equipment and the mutual
recognition of their conformity.
The safety advice in the documentation accompanying this product shall be obeyed. The conformity to
the above directive is indicated by the
CE
sign on the device.
The signed Declaration of Conformity can be downloaded from
http://www.patton.com/certifications/
Legal Notice
Copyright © 2012 Patton Electronics Co
All rights reserved. No part of this publication may be reproduced without prior written permission from Inalp
Networks AG. dba Patton-Inalp AG. Patton-Inalp AG reserves the right to make changes in specifications and
other information contained in this document without prior notice. The information provided is subject to change
without notice. In no event shall Patton-Inalp AG or its employees and associated companies be liable for any
incidental, special, indirect or consequential damages whatsoever, including but not limited to lost profits, arising
out of or related to this manual or the information contained within it, even if Patton-Inalp AG has been advised
of, known, or should have known, the possibility of such damages. Patton, the Patton logo, and Inalp SmartNode
are trademarks of Patton Electronics Company and Inalp Networks AG. SmartWare and SmartView
Management Center are trademarks of Inalp Networks AG. All other trademarks mentioned in this document are
property of their respective owners
.
Patton Electronics Company, Inc., 7622 Rickenbacker Drive, Gaithersburg, MD 20879 USA
5
4
6
3
2
