2
SmartLink M-ATA Quick Start Guide
1.0 Quick Start
• The M-ATA contains no user serviceable parts. The equipment shall be
returned to Patton Electronics for repairs, or repaired by qualified
service personnel.
• The external power adapter shall be a listed Limited Power Source.
Ensure that the power cable used with this devise meets all applicable
standards for the country in which it is to be installed, and that it is
connected to a wall outlet which has earth ground. The mains outlet
that is utilized to power the devise shall be within 10 feet (3 meters)
of the device, shall be easily accessible, and protected by a circuit
breaker.
• Do not work on the system or connect or disconnect cables during
periods of lightning activity.
The interconnecting cables shall be acceptable for external use and shall be rated for
the proper application with respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
The unit should be installed in a dry environment with at least 2 inches (5 cm) of clearance at the sides
and front of the unit to allow air circulation for cooling.
Plug in the telephone (see
figure 1
on page 1).
Plug in the PC or LAN, or a LAN hub/switch.
Plug the power adapter into the power jack on the SmartLink M-ATA (see
figure 1
on page 1). Connect
the other end of the power cord to an appropriate AC power outlet.
Wait 30 seconds after powering the SmartLink M-ATA on, then verify that the green
Power
LED is lit (see
figure 1
on page 1).
By default, the M-ATA will automatically request IP network settings from the LAN using DHCP. To deter-
mine the IP address of the SmartLink, lift the handset off the attached analog phone and dial
* * * *
.
Dial
1 0 0 #
, listen to and record the IP address of the SmartLink. (To manually set the IP address, see
appendix
B.2 “Existing voice prompt configuration”
on page 4 for details).
Use a web browser to connect to the SmartLink M-ATA. The URL will be http://<ip address>. For exam-
ple, if the M-ATA IP address was
10.10.10.2
, the URL would be
http://10.10.10.2
.
The default password is “
root
”.
WARNING
CAUTION
1
2
3
4
5
6
7
