2
Model 3088 Quick Start Guide
1.0 Select configuration method
Before powering up, you must select one of the following methods for configuring your RocketLink-G:
•
Plug ‘n’ Play
—The RocketLink-G comes factory-configured for Plug ’n’ Play configuration when connected
to a service-provider network.
•
DIP Switch
—For deploying the RocketLink-G in back-to-back applications. To use DIP-switch configuration
you must first set the DIP switches to a position other than all OFF or all ON before powering-up the Rock-
etLink-G. To configure your NTU using the DIP switches, refer to the section entitled “Hardware (DIP-switch)
configuration” in the
RocketLink-G Model 3088 Series Getting Started Guide.
•
Software Configuration
—Allows you to modify configurable parameters by connecting a PC to the con-
sole port and issuing software commands. To use software configuration you must set all the DIP switches to
the ON position before powering-up the RocketLink-G. To configure your NTU via the console port, refer to
section “Software (CLI) configuration” in the
RocketLink-G Model 3088 Series Getting Started Guide.
• This device contains no user serviceable parts. The equipment
shall be returned to Patton Electronics for repairs, or repaired
by qualified service personnel.
• AC Powered Units: The external power adaptor shall be a
listed Limited Power Source. Ensure that the power cable used
meets all applicable standards for the country in which it is to
be installed, and that it is connected to a wall outlet which has
earth ground. The mains outlet that is utilized to power the
device shall be within 10 feet (3 meters) of the device, shall
be easily accessible, and protected by a circuit breaker.
• DC Powered Units: The interconnecting cables shall be rated
for proper voltage, current, anticipated temperature, flamma-
bility, and mechanical serviceability.
• Hazardous network voltages are present in WAN ports,
regardless of whether power to the unit is ON or OFF. To avoid
electric shock, use caution when near WAN ports. When
detaching the cables, detach the end away from the device
first.
•
Do not work on the system or connect or disconnect cables dur-
ing periods of lightning activity.
WARNING
