4
ipRocketLink 3086FR Quick Start Guide
2.
Start a HyperTerminal session on the PC using the settings:
9600 bps, 8 data bits, 1 stop bit, no parity, no flow control
3.
Log in to the ipRocketLink using the factory-default login and password:
Login:
superuser
Password: superuser
Login successful
2.2 Modify the IP address
1.
Display current IP interface settings for the ipRocketLink
Ethernet
LAN port.
fi
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
---|------|----------------|----------|--------------
1 | ip1 | 192.168.200.10 | disabled | <bridge>
----------------------------------------------
------
2.
Modify the IP address for the LAN port according to your network requirements.
fi
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
Note
The above IP address is only an example. You must choose an IP address on the same subnet as
your PC
.
3.
Verify the new address is correct and save it in system boot memory.
fi
ip list interfaces <enter>
fi
system config save <enter>
fi
3.0 Connect to the local IP network
Now you can connect the ipRocketLink to your local IP network and complete the remaining configuration from
your PC using a standard web browser.
Connect the ipRocketLink’s
Ethernet
port (green) to the same Ethernet segment as your PC (see
figure 2
). The
front-panel
Ethernet Link
LED should turn on. If it does not, press the rear-panel MDI-X switch so that the
Ethernet
Link
LED illuminates.
