Each Patton 52X-TS Series protector is equipped with a heavy
duty braided metal strap to shunt harmful over-voltages safely to
ground. It is housed in a sturdy, flame retardant plastic case (UL94-5V
flame rating).
Warning: Should your equipment or building be subject to a direct
lightening strike, this product will not provide complete protection.
3.0 INSTALLATION
This section tell you how to open the case, how to connect the
bare wires to the terminal blocks, and how to fasten the strain relief
strap to secure the wires.
Make sure you follow the installation instructions exactly. If the
suppressor is improperly installed, the current limiting feature could be
rendered inoperable. If you have any question as to how your hardware
is grounded, consult the manufacturer's user manual(s).
1.
Open the case by inserting a screwdriver into the side of the
case opening and gently turn the screwdriver. The case will
pop open. Once the case is open, you will see the terminal
blocks.
2.
As show in Figure 2, strip the outer insulation from the wires
about 1 inch from the end.
3
3.
Strip off the insulation on each of the wires about 0.25 inches
(.6 centimeters).
4.
Place the cable through the end plate and under the cable tie
installed on the board. Make a small loop in the cable using
the cable ties provided, to hold the loop in place. Tighten both
cable ties. Figure 3 below shows the correct connection.
5.
Connect the wires to the terminal blocks. Use Figure 4 to
ensure that each wire of the 52X-TS is connected to the
correct corresponding pin number on the opposite side of the
protector. Also shown in Figure 4 is the proper wire pairing for
the 52X-TS.
4
Figure 2. Stripping the 52X-ST Outer Insulation
Figure 1. Opening the 52X-ST Case
Figure 3. Installing the 52X-TS Cable
Figure 4. 52X-TS Differential Pairing and Pin Numbers
Summary of Contents for 52X
Page 5: ......
