Patton electronics 2190, User Manual, Page: 10 / 14

Fax Class 2 commands (continued)
+FDIS: Report remote capabilities
+FDIS= Current sessions parameters
+FDR Begin or continue phase C receive data
+FDT= Data transmission
+FDTC: Report the polled station capabilities
+FET: Post page message response
+FET=N Transmit page punctuation
+FHNG Call termination with status
+FK Session termination
+FLID= Local ID string
+FLPL Document for polling
+FMDL? Identify model
+FMFR? Identify manufacturer
+FPHCTO Phase C time out
+FPOLL Indicates polling request
+FPTS: Page transfer status
+FPTS= Page transfer status
+FREV? Identify revision
+FSPL Enable polling
+FTSI: Report the transmit station ID
4.6 VOICE COMMANDS
This section describes the voice commands on the Model 2190.
The list below provides the voice command codes and its function.
#BDR Select baud rate (turn off autobaud)
#CLS Select data, fax, or voice.
#MDL? Identify model
#MFR? Identify manufacturer
#REV? Identify revision level
#SPK= Speakerphone setting
#TL Audio output transmit level
#VBQ? Query buffer size
Voice Commands (continued)
#VBS Bits per sample
#VBT Beep tone timer
#VCI? Identify compression method
#VGT Set playback volume in the command state
#VLS Voice line select
#VRA Ringback goes away timer (originate)
#VRN Ringback never came timer (originate)
#VRX Voice receive mode
#VSD Enable silence deletion (no function, com-
mand response only).
#VSK Buffer skid setting
#VSP Silence detection period (voice receive)
#VSR Sampling rate selection
#VSS Silence detection tuner (voice receive)
#VTD DTMF/tone reporting
#VTM Enable timing mark placement
#VTS Generate tone signals
4.3 REGISTERS
This section provides information on the Model 2190 S-registers.
The codes and functions to change or read registers are listed below.
Also included in this section is a chart on the register codes and its
function.
4.3.1 COMMANDS TO CHANGE OR READ REGISTERS
Listed below are the Model 2190 command guidelines to change
or read registers. This list provides the command codes and describes
the functions of the codes.
ATSn=??? Changes the value of a register.
"n" = number of register
??? = new value of register in decimal
17 18