Patton electronics 2002 Series, User Manual

Page: 9 / 16

Inverted Data and Control Signals
Position JP1 and JP2 horizontally on the jumper posts to select
inverted data and control signals. Figure 5 shows the position of the
jumpers on the pc board. Table 4 shows the relative signal levels.
Inverted Data and Non-Inverted Control Signals
Position JP1 horizontally top jumper posts and remove JP2 to
select inverted data and non-inverted control signals. Figure 6 shows
the position of the jumpers on the pc board. Table 5 shows the relative
signal levels.
7
Inverted Control and Non-Inverted Data Signals
Position JP2 horizontally on bottom jumper posts to select inverted
control and non-invert data signals. Figure 7 shows the position of the
jumpers on the pc board. Table 6 shows the relative signal levels.
8
Signal Level Data Signals Control Signals
0.0 to 0.4 Volts space inactive
2.4 - 5.0 Volts mark active
Table 6. Inverted Control, Non-Inverted Data Signals
Signal Level Data Signals Control Signals
0.0 to 0.4 Volts mark active
2.4 - 5.0 Volts space inactive
Table 5. Inverted Data, Non-Inverted Control Signals
JP1
JP2
Figure 6 : Inverted Data and Non-Inverted Control Signal Jumpers
JP1
JP2
Figure 7 : Inverted Control and Non-Inverted Data Signal Jumpers
Signal Level Data Signals Control Signals
0.0 to 0.4 Volts mark inactive
2.4 - 5.0 Volts space active
Table 4. Inverted Data and Control Signals
JP1
JP2
Figure 5 : Inverted Data and Control Signal Jumpers
RS-232 Side
TTL Side
RS-232 Side
TTL Side
RS-232 Side
TTL Side