1.0 WARRANTY INFORMATION
Patton Electronics
warrants all Model 1205RC components to be
free from defects, and will—at our option—repair or replace the product
should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials,
and does not cover customer damage, abuse or unauthorized modifi-
cation. If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall
Patton Electronics
be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or consequen-
tial damages arising from the use of or inability to use this product.
Patton Electronics
specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 1205RC generates and uses radio frequency energy,
and if not installed and used properly—that is, in strict accordance with
the manufacturer’s instructions—may cause interference to radio and
television reception. The Model 1205RC has been tested and found to
comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If the Model 1205RC
does cause interference to radio or television reception, which can be
determined by turning the power off or removing the card, the user is
encouraged to try to correct the interference by one or more of the fol-
lowing measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the receiv-
ing equipment into a different AC outlet (such that the computing equip-
ment and receiver are on different branches).In the event the user
detects intermittent or continuous product malfunction due to nearby
high power transmitting radio frequency equipment, the user is strongly
advised to take the following steps: use only data cables with an exter-
nal outer shield bonded to a metal or metalized connector; and, config-
ure the rear card as shown in section 3.4 of this manual.
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the Union European
(EU). A Certificate of Compliance is available by contacting Technical
Support.
1
APPENDIX C
MODEL 1205RC INTERFACE STANDARDS
© Copyright
Patton Electronics Company
All Rights Reserved
16
13- Not Used
12- (TC/) Transmit Clock
11- (XTC/) Network Clock
10- Not Used
9- (RC/) Receive Clock
8- (CD) Carrier Detect
7- (SG) Signal Ground
6- (DSR) Data Set Ready
5- (CTS) Clear to Send
4- (RTS) Request to Send
3- (RD) Receive Data
2- (TD) Transmit Data
1- (FG) Frame Ground
MODEL 1205RC V.35 INTERFACE (DCE WIRING)
Not Used -26
Not Used -25
Network Clock (XTC) -24
Not Used -23
Not Used -22
Not Used -21
Data Term Ready (DTR) -20
Not Used -19
Not Used -18
Receive Clock (RC) -17
Receive Data (RD/) -16
Transmit Clock (TC) -15
Transmit Data (TD/) -14
