10
3. Connect the dual fiber ST or SC connectors on the Fiber Modem
(see Figure 3) directly to the 802.3 compliant multi-mode fiber cable
equipped with male ST or SC connectors or via 802.3 compliant
multi-mode fiber patch cord (not provided) and corresponding ST or
SC fiber wall jacks.
Note
Verify that the cable connecting the TX and RX of the 1170M
Series unit is connected to the RX and TX respectively on the
remote 1170M Series unit or network device. End-to-end multi-
mode fiber connections between two Model 1170M Series
Ethernet Fiber Modems or between one Model 1170M Series
Fiber Modem and other network devices must not exceed 2 km
(1.24 miles), 298.7 m (980 ft) in 100Base-SX mode (Model
1172M only).
Figure 3.
Fiber connector locations
4. Connect the DC power output side of the power supply adapter to
the power jack (see Figure 1 on page 8) on the 1170M Series unit.
5. Connect the AC power side/cord of the power supply adapter to the
appropriate AC power source.
The Ethernet Fiber Modem will power up and LED indicators will illumi-
nate once connected to the power source.
