EN
86
Using the tool
1.
Clean the surface to be sprayed and keep
it free of dust.
2.
Fit the required nozzle into the air cap and
screw them onto the spray gun using the
union nut.
3.
Screw the filled container
6
tightly onto
the spray gun.
4.
Adjust the spray setting and the material
volume (see following page). Test the set-
tings on cardboard or something similar.
5.
Cover all surfaces or parts not to be
sprayed.
6.
Hold the spray gun at an even distance of
10-30 cm to the target object.
7.
Pull the trigger
5
and move the spray gun
evenly cross-wise or up and down, de-
pending on the desired spray pattern.
8.
Begin spraying outside the target area.
Avoid interruptions inside the target area.
9.
Clean air cap
2
, whenever it is clogged
with coating material.
Intended Use
The tool is intended for spraying paints, var-
nishes and glazes. The tool is not intended for
commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Product overview
1
Union nut
2
Air cap
3
Nozzle ø 2,6 mm
4
Front part
5
Trigger
6
Container
7
Power cord
8
Material volume adjustment
9
Rear part
10
Air filter cover
11
Unlock button
12
Unlock air filter cover
BEFORE USE
Unscrew the container
6
, put it on a
sheet of paper and pour in the prepared
coating material.
1
Align the feed tube:
1. For overhead objects
2. For objects lying below
2
Caution!
Never point the spray gun
at yourself, at other people or at ani-
mals.