EN
129
2
1
Product overview
1
Soft grip handle
2
On / Off switch
3
Sanding plate
4
Foam polishing pad
5
Sanding paper
6
Battery release switch
7
Battery (not included)
8
Speed dial
9
Dust box
APPLY DUST BOX
Before sanding attach the dust box
to
the dust port until it snaps into place.
Never sand without dust collection
box. Dust involves hazards, e.g. for
the eyes due to particles suspended into
the air.
1
EMPTY DUST BOX
Pull the dust box
from the tool. Re-
move the box cover and shake out
the dust.
Caution!
Make sure the tool is
switched off and the battery re-
moved.
2
Using the tool
Intended use
The tool is intended for polishing and dry
sanding of wood, plastic, metal and coated
surfaces. It is not suitable for plaster or dry-
wall filler. The tool is not intended for com-
mercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Slide the battery (not included) onto
the charger and check its LED:
Red:
Charging
Green:
Battery is fully charged
Flashing Red:
Battery is defective
Flashing Green:
Battery is too hot/
cold
2
1.
Make sure your workpiece can not slip.
2.
To switch on the tool, press the on/ off
switch
at the position
I
. Only thereaf-
ter start working while holding the tool
firmly with both hands.
3.
Move the tool slowly over the workpiece
in parallel lines, circles or crosswise
movements and successive passes.
4.
Empty the dust box
9
every 5-10 min and
replace the sanding paper
5
regularly for
efficient sanding.
5.
To switch off the tool, first lift the sander
off the workpiece and then press the on /
off switch
at the position
0
.
CHARGE BATTERY
Plug the charger (not included) into a
suitable wall socket.
Caution!
Only use the battery
charger specified in technical data
to charge the battery.
1
1
1
2
9
4
8
3
2
6
5
7
