6
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety rules
The corresponding safety information can be
found in the enclosed booklet.
2. Proper use
The equipment is designed for the grinding/sanding
of wood, iron, plastic and similar materials using the
appropriate grinding/sanding paper. The eccentric
grinder/sander is not suitable for wet grinding/
sanding.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
3. Layout (Fig. 1)
1 Grinding/sanding disk
2 Housing
3 Locking knob
4 Operating switch
5 Connection for dust bag
5 Dust bag
7 Speed setting
8 Additional handle
9 Pushlock button
4. Technical data
Voltage
230 V ~ 50 Hz
Power rating
430 W
Sanding surface
125 mm dia.
Disk size
125 mm dia.
Oscillations per minute
4.000-12.000
Safety insulated
II /
쏾
Sound pressure level L
pA
82 dB
Sound power level L
WA
96 dB
Vibration a
hv
6,96 m/s
2
Weight
2,3 kg
5. Preparations
5.1 Attaching the dust bag (Fig. 2)
Press the pushlock button (9) on the left and right
side of the dust bag (6). Then slip the dust bag (6)
onto the connection for the dust bag (5).
The dust is extracted directly through the
grinding/sanding paper and the grinding/sanding disk
and into the dust bag.
Important!
In the interests of your health, always use the
dust bag!
5.2 Fitting the sanding disk
Easy disc replacement thanks to Velcro-type
backing. Make sure the apertures in the disk coincide
with those in the backing pad.
5.3 Adjusting the additional handle (Fig. 3)
Slacken the screw (a) and move the additional
handle (8) to its optimal position. Lock the additional
handle (8) in place by tightening the screw (a).
6. Starting up
6.1 Switching on and off (Fig. 1)
To switch on:
Press On/Off switch 4.
To operate:
Secure switch 4 with the lock
button 3.
To switch off:
Press On/Off switch 4.
Anleitung E-ES 430_SPK7:_ 02.07.2007 9:08 Uhr Seite 6
