Page 5 of 6
CARE AND MAINTENANCE
Clean the glass and coated metal surfaces with a non-abrasive cleaner. Do not use any cleaners with chemicals,
solvents or harsh abrasives, The motion detecting lens is coated with a specially painted finish and requires special
care when cleaning. Use only a soft dry cloth to dust or wipe the lens area.
Another area that will need special attention is the photocell window located right near to the “TIME/TEST” knob. The
photocell detects light through this small window. Keep this area clean to prevent dirt from collecting. Excessive
accumulation of dirt or dust on the photocell window may cause the lights to come on during the day.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
If the light will not come on
There may be a poor connection between
the lamp fixture and supply wires inside the
outlet box.
Double check the wire connections.
The photocell may be detecting daylight and
preventing the light from coming on.
Turn the “TIME/TEST” knob to the
TEST position to turn off the photocell,
or wait until dusk and recheck.
Bulb may need replacement.
Remove bulb and check for a break in
the filament wire. Replace bulb if
necessary.
Coverage dial on either side of the motion
detector lens may be set so that the detector
is blocked.
Turn the dials downward to increase the
coverage area.
Motion detector lens may be installed upside
down. Gently pull lens out. The three drain
holes should be on the bottom.
Re-install lens to proper position.
The fixture will only operate on standard
120VAC/60Hz power.
Have power supply checked by
qualified electrician.
Glass Panel
X5
9473CS
The following parts are available for reorder if damaged or missing. Call our toll free at 1-800-887-6326.
200818
Assembly Kit
4807MM (1 SET)
Spare Parts List:
Cross Bar Unit
X1
Mounting Screw
X2
Wire Connector
X3
Bolt Nut
X2
AA
BB
CC
DD
Bottom Finial
X1
4805FF
EE
Top Finial
X1
4807FF
GG
Decorative Cap Nut
X2
4805CT
