Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
●
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper.
SAFETY INFORMATION
Page 2 of 4
200730
ASSEMBLY INSTRUCTIONS
3.
Attach the ceiling pan (A) to the
mounting strap unit (AA) by
inserting the threaded pipe,
then secure it with the washer
(FF), metal pad (GG) and end
cap (DD).
1. Remove the four bolt nuts from
the metal frame (B).
Turn off the power at fuse or circuit box.
2. Secure mounting strap unit (AA)
to outlet box by using two
mounting screws (BB).
Note: The depth of threaded
pipe on the mounting unit may
need to be adjusted to properly
fit the fixture.
2
AA
BB
Outlet Box
AA
CC
4
Threaded
Pipe
3
AA
GG
FF
A
DD
1
A
B
Bolt Nut
4. Pull out the source wires from the
outlet box. Make wire connections
using wire connectors (CC) as
follows:
Connect the smooth wire
(marked) from the fixture to the
black wire (hot) from the power source.
Connect the ribbed wire (unmarked) from the fixture to
the white wire (neutral) from the power source.
Attach the fixture grounding wire to the mounting strap
unit (AA) with the green grounding screw. Then,
depending on local code, connect it to the house
grounding wire with the wire connector (CC).
Carefully put the wires back into the outlet box.
