ASSEMBLY INSTRUCTIONS
3
Backplate
STEP 4:
a. Line up holes on the backplate and mounting
holes on the folded edge of the crossbar(AA).
b. Secure by threading mounting screws(DD) into the
mounting holes on the crossbar (AA). Do not fully
tighten.
c. Once all screws are threaded into the crossbar,
tighten with screwdriver.
DD
AA
STEP 2:
Note
: Prior to installation, place a towel or thick
cloth under the installation site to prevent loss of
mounting hardware if dropped.
a. Remove the Crossbar (AA) from the Backplate on
the Fixture Body (A) as shown in STEP 4.
b. Align cross bar (AA) to the outlet box so that the
mounting holes on the cross bar (AA) are on the
.
c. Secure the Crossbar (AA) to the outlet box (not
included) with Outlet Box Screws (CC).
side
STEP 5:
a. Install correct bulbs referring to fixture markings
and/or labels for maximum wattage.
STEP 1:
a. Remove the Styrofoam from the Cage (B).
b. Attach the Cage (B) onto the Fixture Hood and
secure with Lock Screws (EE). Hand-tighten until
snug.
B
Outlet Box
AA
CC
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 3:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply
around
on mounting bracket, no less than 2 inches
from the end of the wire. Tighten
.
2. Connect fixture
to
wire with wire connector.
b) Supply Wire:
1. Connect the
to the
with wire connector.
2. Connect the
wire to the
with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
ground wire
green ground
screw
ground screw
ground wire
supply ground
supply white wire
white
fixture supply wire
supply black (or red)
black fixture supply wire
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
EE
Styrofoam
Fixture Hood
