SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
●
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
210607
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at the fuse or circuit box.
1. Secure the mounting plate
unit(AA) to outlet box with
mounting screws(BB).
CC
A
AA
2
2. Pull out the source wires from
the outlet box, make wire
connections using wire
connectors(CC) as follows:
---Connect the black(hot) wire
from the fixture to the
black(hot) wire from the
power source.
---Connect the white(neutral)
wire from the fixture to the
white (neutral) wire from the
power source.
---Attach the fixture ground
wire(bare wire) to the mounting
plate unit(AA) with the green
ground screw, then connect
fixture ground wire to the
house ground wire with a wire connector(CC).
Carefully put the wires back into the outlet box.
1
Outlet Box
Green
Ground
Screw
BB
AA
