Page 2 of 4
210619
Turn off the power at the fuse or circuit box.
1. Attach the mounting
plate unit(AA) to the
outlet box using two
mounting screws(BB).
Note: Make sure that
the two holes on the
side of the mounting
plate unit(AA) are
lined up vertically to
make the fixture level.
1
BB
AA
Outlet Box
Green Ground Screw
2. Pull out the source
wires from the outlet
box
，
make wire
connections using
wire connectors(CC)
as follows:
---Connect the black
(hot) wire from the
fixture to the black
(hot) wire from the
power source.
---Connect the white(neutral) wire from the fixture to
the white(neutral) wire from the power source.
2
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
SAFETY INFORMATION
---Attach the fixture ground wire (bare wire) to the
mounting plate unit(AA) with the green ground screw,
then connect the fixture ground wire to the house
ground wire with a wire connector(CC).
Carefully put all of the wires back into the outlet box.
AA
CC
