Wall Mount - No J-Box
• Turn on the power at the main circuit breaker.
Wall Mount - Over a 3-1/2 inch Octagonal J-Box
• Position the junction box mounting holes over the junction box and secure.
3
• Reattach the driver cover assembly to the luminaire housing by positioning the driver cover assembly in the
correct position, and then pressing the cover back until it is retained by the slots. Be sure not to pinch any
wires under the cover.
• Reattach the lens onto the luminaire housing.
• Remove the center knockout from the back of the luminaire. The knockouts may be removed without tools by
pressing firmly on the knock out and then twisting the knockout unitl it comes free. If necessary, carefully use a
prying tool or pliers to remove the knockout. File any sharp edges that might cause damage to the power
wires.
• Feed the luminaire wiring through the back knockout and into the junction box.
•Make connections from the incoming power wires to the driver input power wires. Use the enclosed wire nuts
to make these connections (Refer to wiring diagram below).
• Remove the lens by carefully pressing in at the bottom of the lens, and then pulling the lens up and off.
• Remove the LED driver cover by pressing at the bottom of the cover, and releasing the cover from the slots
in the luminaire housing. Avoid touching the LED surfaces, as direct contact can damage the LEDs.
• Remove the part bag from beneath the LED driver cover, and remove all of the parts from the bag.
• Remove the round knock-out in the luminaire housing that is nearest the location of incoming power wires.
The knockouts may be removed without tools by pressing firmly on the knock out and then twisting the
knockout unitl it comes free. If necessary, carefully use a prying tool or pliers to remove the knockout. File any
sharp edges that might cause damage to the power wires.
• Using a Phillips screwdriver, screw the enclosed wood screws into the mounting surface. If necessary, use
screw anchors (provided by others) to securely attach the screws in soft surfaces, such as drywall. Do not fully
tighten the screws.
• Position the luminaire housing in the desired location, and then mark and drill mounting holes at the narrow
ends of the keyhole slots.
• Position the luminaire housing so that the screws installed in step 6 are aliged with the wide, rounded end of
the keyhole slots. Push the housing over the screw heads, and then slide the ousing so the screw heads are
aligned with the narrow end of the keyhole slots. Securely tighten the screws.
• Make connections from the incoming power wires to the driver input power wires. Use the enclosed wire nuts
to make these connections (Refer to wiring diagram below).
MOUNTING INSTRUCTIONS
