CARE AND MAINTENANCE
TROUBLESHOOTING
Wipe the fixture with a soft cloth, do not use abrasive cleaner
WARNING: Failure to disconnect power supply prior to troubleshooting any wiring issues may result in serious injury.
Problem: Light does not come on.
1. Check power (circuit box and wall switch) to fixture.
2. Verify that bulb is installed correctly
3. Check to be sure lamp is plugged in.
4. Replace defective bulb with same type of bulb.
FIVE-YEAR LIMITED WARRANTY: If, during normal use, this PATRIOT LIGHTING lighting fixture breaks or fails due
to a defect in material and workmanship within five years from the date of original purchase, simply bring this lighting
fixture with the original sales receipt back to your nearest MENARDS store. At its discretion, PATRIOT LIGHTING
agrees to have the product or any defective part(s) repaired or replaced with the same or similar PATRIOT LIGHTING
product or part free of charge, within the stated warranty period, when returned by the original purchaser with original
sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs; (2) does not cover
damage that has resulted from abuse or misuse; and (3) does not cover any losses, labor, injuries to persons/property
or costs. This warranty does give you specific legal rights and you may have other rights, which vary from state to state.
R
R
R
R
A
1. Screw tightly the middle iron pipes (D) into the top iron pipes (C), and then
screw tightly the bottom iron pipes (E) into the middle iron pipes (D).
2. Place the bottom iron pipes (E) through the holes on the base (F),
and then attach the octagonal washers (BB), tooth washers (CC)
and the hex nuts (EE) on the pipes (E) and secure them together
with the wrench (AA).
3. In case, the jimmy screws (FF) on the lamp head stem(s) or on the
switch(s)(I) cap are untight, you can tighten them with the allen key (DD).
4. Remove socket rings (B) from the each socket (G) on the lamp.
Attach the glass shades (A) to the sockets (G) and secure them
with socket rings (B).
5. Install three medium base bulbs (H, not included) on the sockets.
Note
: Do not exceed the maximum 60-watt incandescent bulbs
6. Remove pre-assembled cap from the power cord plug and
connect to the wall outlet.
7. Rotate the on/off switche(s) (I) on each lamp head and enjoy.
Note
: The maximum adjustable pivot angle
of the lamp heads are 150°
AA
BB
CC
DD
EE
FF
B
G
F
E
C
D
ASSEMBLY INSTRUCTIONS
1
2
H
I
3
4
Note
: Do not twist the power cord
Pull the power cord until taut.
