Page 2 of 4
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
PREPARATION
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
●
Select dimmable LED bulb or incandescent bulb when connecting to dimmer.
190724
Turn off the power at fuse or circuit box.
2. Attach the mounting strap unit (AA)
to the outlet box using two mounting
screws (BB). Adjust the length of
the preinstalled threaded pipe if
necessary.
1. Unscrew the end cap (DD).
Remove the rubber pad (EE)
and the mounting strap unit (AA)
from the backplate (A).
3. Install bulb (FF) .
See relamping label at socket
area or packaging for maximum
wattage allowed (Max.60W).
AA
BB
2
Threaded Pipe
DD
EE
1
AA
A
Threaded Pipe
Backplate
3
FF
4.
Loose the three set screws on the
glass holder, then attach the glass
shade (B) to the glass holder
carefully and secure it with the three
set screws.
NOTE: Please don’t over tighten,
breakage could occur.
4
A
B
Set Screw
Glass Holder
