Page 3 of 4
231102
ASSEMBLY INSTRUCTIONS (continued)
5. Connect the cable from the
solar panel (B) to the bottom of
backplate (A) (Fig.5). Only use
solar panel (B) to charge the
light, other external charger
may damage the light fixture.
5a
B
Solar Panel Adjustable
B
5b
4. Fix the solar panel bracket to
the wall:
4a.
For wooden outdoor
surfaces:
Attach the solar panel
bracket to the wall by using
the drywall screws (EE)
through the set holes on the
solar panel bracket
into the
wall.
Note: The solar panel is equipped with a 9ft.(2.7M)
can connecting wire,so the light fixture and solar
panel be installed up to 9ft.(2.7M) apart.
4b. For cement and drywall
surfaces:
Attach the
solar panel bracket
to the wall and mark the set
holes on the wall surface for
drilling. Remove the
solar
panel bracket
and drill the
set holes. Insert the
anchors (DD) into the set
holes. Then, attach the
solar panel bracket
to the wall,
secure the drywall screws (EE) through the holes on
the
solar panel bracket
into the anchors (DD).
Set Hole
Solar Panel
Bracket
4a
Wooden
EE
Set Hole
Solar Panel
Bracket
4b
EE
Drywall
DD
Power switch setting:
a.) Set the toggle switch to
"
OFF
"
position: The power will turn off.
(Fig.A)
b.) Set the toggle switch to
"
AUTO
"
position: The light warms up for 10 seconds, then it will turn to sensor mode. At
dusk, the light will stay off and will turn on automatically when motion is detected. It will remain on 20 seconds
motion is no longer detected, and then turn off automatically. (Fig.A)
FUNCTION AND OPERATION
Notes:
1. The sensitivity of the motion sensor will increase as the environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every 1 or 2 months to ensure maximum sensitivity.
2. The fixture will provide a detection distance of up to 30 feet. (See Fig.7)
3. The sensor detects movement across a detection range of 120 degrees. (See Fig.8)
4. The sensor will be more sensitive to motion across its detection path than motion directly towards it. (See Fig.9)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or other light source.
Fig.6
Battery
Battery
Cover
Rubber
Pad-a
Screw
A
To Replace The Battery
1. Remove the four screws and four rubber pads-a
located on the battery cover. (Fig.6)
2. Carefully remove old batteries from battery compartment and replace with one
new 18650 3.7V 1200mAh Li-ion battery. Make sure polarity is correct. (Fig.6)
3. Restore the battery cover.
A
5
B
Fig.A
OFF / AUTO
View Fig.A
