Page 4 of 6
FUNCTIONS AND OPERATIONS
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
5`
6`
10`
30`
Fig.6
Fig. 7
Least sensitivity
Most sensitivity
Sensor
Fig. 8
Motion
Motion
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets colder. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
ensure maximum sensitivity.
2. When installed at a height of 6.5 feet, at 77 degrees Fahrenheit,
the light will provide a maximum detection distance of 30 feet
and detection range of 150 degrees. (See Fig.6 Fig.7)
3. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.8)
4. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
Choose a mode by turning the rotary knob. The light will turn on immediately when power is applied. Wait for 30
seconds to allow the sensor to warm up.
1. Test MODE (daytime and nighttime operation.)
● The light will turn on when motion is detected, and stay on as long as the motion continues. The light will turn off
after 5 seconds when motion is no longer detected.
2. Auto MODE (nighttime operation only)
● At dusk, the light will turn on when motion is detected, and stay on as long as the motion continues. When the
motion stops, the light will remain on for the predetermined time set (5~180 seconds) and then turn off.
● The light will turn off automatically at dawn.
3. PC MODE (nighttime operation only)
● The light will turn on automatically at dusk and turn off automatically at dawn.
Customization Options
Shut-off Delay
Fig. 5
(View from back of sensor lens)
1. The Shut-off delay is the length of time that the light will stay on
after motion stops.
2. The Shut-off delay can be adjusted by using the "Time" knob when
the knob is set in "Auto" mode.
3. The range of shut-off delay is 5 seconds to 3 minutes.
4. Rotate the knob clockwise for increasing the shut-off delay.
5. Rotate the knob counterclockwise for decreasing the shut-off delay.
Sensitivity of Motion Sensor
1. The sensitivity can be adjusted from 5 to 30 feet by using the
"Sens" knob. (See Fig.5).
2. Turn the knob clockwise for increased sensitivity.
3. Turn the knob counterclockwise for decreased sensitivity.
Auto Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 0.5~3 Seconds
Turn wall switch OFF-ON
in 0.5~3 Seconds
Fig. 4
4. Manual Override MODE (nighttime operation only)
●
To shift to the manual override mode, set the switch to "Auto" mode.
Turn the wall switch "OFF" and then turn it "ON" within 3 seconds.
The light will stay on through all night. To restore to the "Auto" mode,
turn the wall switch "OFF" and then turn it "ON" within 3 seconds
again. (See Fig.4)
●
The light will last for one night only and turn off automatically at
dawn.
Note: 1. Always keep the wall switch in the "ON" position
(including the daytime).
2. Please notice the warm up time is 30 seconds, any
operations are invalid during this time.
150˚
221116
Time
Mode
Sens
Auto
Test
PC
