Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
●
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
For use with Patriot Lighting® Track sku 349-6382, 349-6394, 349-6419, 349-6420, 349-6433, 349-6436 and 349-6437.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS
1
2
DD
AA
AA
BB
3
4a
3. Predrill holes in the mounting
surface.
Note: Drill a 5/8 in. wide hole
at each mark on mounting
surface when using toggle
bolts.
Electrical
Adapter
Screw
Track
2. Position the track under the
mounting bracket(AA) and
secure the track with two
screws, mark the target on
the mounting surface from
the key hole. Loosen the
screws from the mounting
bracket and remove the
track from the mounting
surface.
Track
Track
key hole
Toggle Bolt
4. Track installation (Hardware
are not included):
a. For wooden ceiling:
Attach the track to the
mounting bracket by aligning
predrilled holes. Secure the
track screws through the
holes of the track and toggle
bolts, and then attach the
toggle bolts into the holes of
the wooden ceiling until the
toggle bolts were secured.
Wooden Ceiling
Track Screw
Turn off the power at fuse or circuit box.
1. Connect the black wire of
electrical adapter to the
house hot wire and the white
wire of electrical adapter to
the neutral wire using wire
nuts(DD) provided.
Connect the green wire of
electrical adapter to the
house grounding wire with
the wire nut(DD).
Tuck all the wires into outlet
box.
Fasten the mounting bracket(AA) to the outlet box
with two mounting screws(BB).