Page 4 / 6
150619
Customization Options:
Shut-off Delay
● The shut-off delay is the length of time the light will stay at brightness after motion is detected.
● You can set the shut-off delay by rotating the Time knob arrow so it points to the desired time setting (from 5
seconds to 3 minutes). To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay,
turn the knob counterclockwise.
● When slide the mode selector to “3H” or “6H” or “D2D”, the light turns to low-level brightness automatically.
It turns to high-level brightness when motion is detected, and stays on as long as the motion continues.
Then switches back to low-level brightness about 5 seconds after motion is no longer detected.
2. OFF MODE (nighttime operation only)
● To shift to the “OFF” mode, slide the switch to “OFF” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light stays off, the light turns on when motion is
detected, and stays on as long as motion continues. When the motion is no longer detected, it remains on for
the predetermined time you set (5s ~ 3min), and then turns off automatically.
● The light turns off automatically at dawn.
3.
3 HOUR MODE (nighttime operation only)
● To shift to the “3H” mode, slide the switch to “3H” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light turns to low
level brightness automatically.
From this moment on, it will remain on for 3 hours. During this 3 hours, when motion is detected, it turns to high
level brightness, and stays on as long as motion continues. When the motion is no longer detected, it remains
high level brightness for the predetermined time you set (5s ~ 3min), and then turns to low level brightness
automatically. After the 3 hours, it turns off. when motion is detected again, it turns to high level brightness,
and stays on as long as motion continues. When the motion is no longer detected, it turns off after the
predetermined time you set (5s ~ 3min).
● The light turns off automatically at dawn.
4.
6 HOUR MODE (nighttime operation only)
● To shift to the “6H” mode, slide
the
switch to “6H” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light turns to low
level brightness automatically.
From this moment on, it will remain on for 6 hours. During this 6 hours, when motion is detected, it turns to high
level brightness, and stays on as long as motion continues. When the motion is no longer detected, it remains
high level brightness for the predetermined time you set (5s ~ 3min), and then turns to low level brightness
automatically. After the 6 hours, it turns off. when motion is detected again, it turns to high level brightness,
and stays on as long as motion continues. When the motion is no longer detected, it turns off after the
predetermined time you set (5s ~ 3min).
● The light turns off automatically at dawn.
5. D2D MODE (nighttime operation only)
● To shift to the “D2D” mode, slide switch to “D2D” position, and rotate Time knob arrow to the desired time
setting (between 5 seconds and 3 minutes). At dusk, the light turns to low level brightness automatically,
it turns to high level brightness when motion is detected, and stays on as long as motion continues. When the
motion is no longer detected, it remains on for the predetermined time you set (5s ~ 3min), and then turns
to low level brightness.
● The light turns off automatically at dawn.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position
(including the daytime).
