Patriot Docks
Assembling the frame:
Two Lift Tubes are joined together using the Mending Insert, secure
using 3/8”x 2” bolt. Repeat this step for the other Lift Tubes as well
as for the two pair of Stringer Tubes. This will create the 9’ frame
pieces.
The Stringer Tubes are then secured to the Lift Tubes using the pre
-
drilled mounting holes and 3/8”x 2.5” bolts.
Aluminum Jack:
Each aluminum jack is mounted using
a Backer Plate and four 3/8”x2
-
1/2”
bolts. All the jack supports should be
orientated toward the entrance of
the lift (as pictured).
Typically, the jack is mounted using
the very bottom set of mounting
holes in the flange. For deeper water
applications the unit can be mounted
higher, creating a higher starting
point.
The drop leg base is comprised of
two pieces, bolt the vertical tube to
the flat base then insert the vertical
into the jack and set desired height.
The jack fender is installed last using
two 3/8”x 3
-
1/2” bolts.
Glides are installed after
frame has been assembled.
Mark the location where
the Glide will be installed
and pre
-
drill 1/8” pilot
holes. Use included
mounting screws to secure
the Glides.
54” Tubes
24” Insert
www.patriotdocks.com