Contact us for assistance: (866) 985-7877 | www.wtliving.com
4
P
REPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts
are missing,
please contact Customer Service at (866)-985-7877, Monday-Friday, 9 a.m. - 6 p.m. EST or
email at [email protected].
Place all parts on a soft, level surface for assembly. Estimated Assembly Time:
2
0 Minutes | DO NOT over tighten hardware
!
ASSEMBLY
1
Assemble the seat: insert the oblong pegs at the
bottom of each side of Seat Back
A
into the
oblong
holes drilled opposite the curve of the Seat
B
as
shown. Insert a Screw
1
through the hole drilled in
the inside of the curve and tighten into the Seat
Back. Repeat to fasten the other side.
A
B
1
1
Hardware Used:
1
Screw (7x90) x 2
2
Connect the Arms
C
/
D
and Brace
E
:
insert the
oblong peg at one end of the Brace
E
into the oblong
hole drilled in the side of Right Arm/Leg
D
. Fasten the
two pieces together using a Screw
1
. Repeat to
attach the Brace to the Left Arm/Leg
C
.
Attach the arms to the assembled Seat
B
:
locate the
hole drilled on the right side of the seat (a few inches
back from the front edge) and align it with the hole
drilled above the notch in the front right leg, resting
the side of the seat on the notch in the inner edge of
the right leg. Connect the two pieces using a
Bolt
2
.
Repeat to
attach
the
left
side.
Attach the arms to the Seat Back:
align the hole
drilled through the back end of the right arm with the
hole about halfway down the right side of the
Seat
Back
A
. Insert a
Bolt
2
and tighten to connect.
Repeat to attach the left side.
Check that all hardware is secure, being careful not to
over-tighten. Your Vega chair is ready for use!
Hardware Used:
1
Screw (7x90) x 2
2
Bolt (6x40) x 4
1
2
2
2
2
1
C
D
E