Pathway Connectivity
VIA 12 Manual
V3 – April 2015
9
Advanced Settings
Menu Item
Menu Options
VLAN Support
Disabled (default)
Enabled. Must be enabled to show VLAN Setup and Ring Protect feature
VLAN Setup
VLAN Range Start: <x>
Specifies lowest VLAN ID# available.
Valid range: 1 to 4095. Default is 1.
VLAN Range End: <x>
Specifies highest VLAN ID# available.
Valid range: 1 to 4095. Default is 10.
Management VLAN:<x>
Specifies the VLAN ID# used by the
management processor. Default is 1.
This value MUST be within the range specified
by the range start and end set above, or you will
not be able to configure the switch.
VLAN Config/Status
VLAN#
Network Settings See below
DHCP Server
Disabled (default)
Enabled
IGMP Snooping
Disabled (default)
Enabled
IGMP Querier
Disabled (default)
Enabled
Current Multicast
Groups
See below
Ring Protect
Setup
Ring Protect Mode
Disabled (default). Ring is turned off.
Master: Switch with master responsibility for
monitoring ring. Only one Master is allowed
Transit: All other switches are set as Transit
Primary Port: <x>
Designates which port to use as the active
uplink port to other switches. Valid range is port
11 thru 14 only (models 6740, 6741, 6742) or
ports 9 thru 11 (model 6730).
Secondary Port: <x>
Designates which port to use as the fall back
link to other switches. Valid range is port 11
thru 14 only (models 6740, 6741, 6742) or ports
9 thru 11 (model 6730).
Control VLAN: <x>
Specifies the VLAN ID# used to determine the
integrity of the ring. may not be used for any
other traffic. Valid ID# is any ID outside the
range set in VLAN setup. Default is VLAN 4095.
Alternate Art-
Net Mapping
Disabled
Enabled (default).
QoS Settings
Off (default)
Standard
Dante Strict
