Input connections
Connections
PUSH
Input and output terminals
Speakers terminals
4
5
To Right channel speakers
To Left channel speakers
Power cord to
AC wall outlet
Balanced
(XLR) inputs
RCA output
RCA inputs
CAUTION:
When connecting your Logos to
other components, make sure the unit is off.
NOTE:
Pathos Acoustics recommends to
use only high quality interconnect and
power cables. Using not appropriate cables
can prevent your amplifier, your sources and
your loudspeakers from delivering their full
potential. Make sure all cable terminations
are of high quality, free from shorts or cold
solder joints.
The wiring to and from the amplifier should
be arranged in a neat way. It is advisable to
separate AC cords form signal and speakers
cables, as to avoid hums and noise from
being introduced into your system.
All input and output connectors are clearly
marked in the back panel to indicate use.
The following are the available inputs and
outputs:
- One RCA Tape output terminals (L, R)
- One RCA Pre output terminal (L, R)
- Five RCA line input terminals (L, R)
- Two balanced line input terminals (L, R)
- Right channel speaker terminals (+ -)
- Left channel speaker terminals (+ -)
-
AC Power Socket
All right channel inputs and ouputs are
marked with the letter R; left channel inputs
and outputs are marked with the letter L.
Positive speaker connectors are marked
with the ; negatives are marked
All input connectors are clearly indicated in
the back panel of your Logos.
Tape out terminals and input terminals from
3 to 7 utilize unbalanced RCA connectors.
The inputs marked Aux 1 and Aux 2 utilize
balanced 3-pin XLR connectors. When
using very long cables, the use of balanced
connectors is highly recommended, for both
electrical and sonic reasons, in order to
reduce noise and not incur significant signal
loss.
The pin assignment for the XLR terminals is
(as indicated in the back panel):- pin 1
shield (ground) - pin 2 non inverting input
(hot or +)- pin 3 inverting input (-)
Speaker out terminals are clearly indicated
in the back panel of your Logos.
Positive output terminals are marked with
red colour.
Left channel terminals are located at your
left and marked with the letter L; right
channel terminals are located at your right
and marked with the letter R.
PRE OUT
PRE out
