Press
RECEIVER INSTALLATION
Audio output connection
There are two audio outputs on the back of the Diversity RDU216
receiver. Mic-level balanced and Line-level unbalanced. Use shielded
audio cable for the connection between the receiver and the mixer. If
the mixer / amp is a 1/4" phone jack, connect a cable from the 1/4"
unbalanced audio output from the receiver to the mixer / amp. If the
mixer has an XLR input, connect a cable from the balanced XLR audio
output from the receiver to the mixer input.
For best operation, the receiver should be at
least 1m above the ground and at least 1 m
away from a wall or metal surface to minimize
reflections. The transmitter should also be at
least 1 m away from a wall or metal surface to
minimize reflections. The transmitter should
also be at least 1 m away from the receiver, as
shown in Fig. 5
Keep receiver antennas away from noise
sources.
True Diversity:
True Diversity utilizes two receiver channels to
avoid “dropout” or loss of RF signals created
by waves propagating in a reflective, or
m u l t i p a t h
e n v i r o n m e n t .
T h e
R D U 2 1 6
incorporates an advanced microprocessor that
selects the audio from the antenna and
receiver channel with the best RF signal.
4
Fig.5
7
MW165U uses a 9V battery for power. To change or replace the battery. Please remove the antenna cap first, then
press at the bottom of battery compartment to release the cover as shown in the figure below.
BATTERIES
CAUTION
The positive ( + ) pole of battery must face downward. Many batteries are known to have leakage problem of
conductive and corrosive liquid. Please observe the rule to remove the batteries if they are not to be used for
a period of a few days.
1. Capsule with metal grill
2.
3.
4. Power on / off switch
5.
Battery indicator
Sensitivity switch
Battery compartment
6. Antenna Cap
2
3
1
4
5
6
HAND-HELD MICROPHONE MW165U
PROFESSIONAL AUDIO & SOUND
®
