7
Safety Instructions
12. NEVER DRIVE FASTENERS INTO AREAS WITH
CONCEALED HAZARDS.
Always check the area behind the work surface for
electrical wiring, gas pipes, water pipes, sewer drains
or other potential hazards.
13. ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED
FOOTING WHEN ON LADDERS, PLATFORMS OR
OTHER HIGH LOCATIONS.
14. ALLOW ONLY QUALIFIED PERSONNEL TO
OPERATE THE CORDLESS FINISH NAILER.
15. PROPERLY STORE FUEL CELL.
16. ALWAYS STORE THE TOOL WITH THE FUEL
CARTRIDGE AND BATTERY REMOVED.
17. KEEP THE TOOL CLEAN.
A clean tool is less likely to jam or malfunction.
18. KEEP YOUR HANDS CLEAR OF THE WORK AREA
SURFACE.
WARNING
Never over-reach, since
tool recoil may cause a
loss of balance. Always
be aware of edges and
drop-offs when nailing on
rooftops and other high
locations. Keep them in
full view.
WARNING
Only persons who have
read and fully understand
all tool operation, safety
a n d m a i n t e n a n c e
instructions should be
allowed to operate the
tool.
WARNING
A fastener may exit at an
angle unexpectedly and
cause injury.
WARNING
Battery Disposal:
IMPORTANT SAFETY INSTRUCTIONS!
SAVE THESE INSTRUCTIONS!
DANGER
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, CAREFULLY
FOLLOW THESE INSTRUCTIONS
CHARGING SYSTEM SAFETY
INSTRUCTIONS!
The Paslode batteries contain lithium and should be
recycled or disposed of properly. It is illegal in some
areas to place a lithium battery into the trash or solid
waste stream.You may contact your local recycling center
for information on where to return the spent battery or call
1-800-822-8837 for information on battery recycling in
your area.
Always store fuel cartridges
where they will not be
exposed to an open flame,
sparks or temperatures
above 120° F (49° C).
Store the fuel cartridge in the case with the cordless
finish nailer
For connection to a supply outside North
America, use an attachment plug adapter
of the proper configuration for the power
outlet, if needed.
